NOJOOMALDUHA LCC Co. is an UAE EPC contractor for desing and fabrication of the Natural gas Dehydration package.
Natural gas usually contains a large amount of water. This water causes several problems for downstream processes and equipment, such as corrosion or freezing in pipelines.
Glycol-based gas dehydration is a technology for the removal of both water and CO2 from natural gas.
Description :
Glycol is fed to the top of an absorber, where it comes into contact with the wet natural gas stream. After leaving the contactor, the rich glycol is routed to the regeneration package for purification.
NOJOOMALDUHA LCC Co. is an UAE EPC contractor for desing and fabrication of the condensate polisher package.
In this package the condensate is collected and then used as boiler feed water. Prior to re-use, the condensate must be purified or “polished”, to remove impurities .Therefore a condensate polisher is used as part of the steam cycle. It is filled with polymer resins which are used to remove or exchange ions such that the purity is near distilled water.
Applications:
• The removal of impurities both dissolved (i.e. silica oxides and sodium) and suspended matter (ex. iron oxide ) particulates which have the potential to cause damage to the boilers, steam generators, reactors and turbines.
• The removal of minerals has the secondary effect of maintaining the pH balance of the water near neutral by removing ions that would tend to make the water more acidic .This reduces the rate of corrosion where water comes in contact with metal.
• The condensate deoiling package is used to remove potential hydrocarbon traces from steam condensates. It supply with client request.
NOJOOMALDUHA LCC Co. is an UAE EPC contractor for desing and fabrication of the Chemical Injection package. These packages are for sending chemical to process package.
The complete system includes:
Skid Structure
Chemical storage tank
Two dosing pumps (as per API – 678)
Instruments
Electrical local panel
Valves
Calibration column
Filter
Mixer
Pulsation Damper
NOJOOMALDUHA LCC Co. is an UAE EPC contractor for desing and fabrication of the fuel gas packaging. Most users of fuel gas require gas that is free of liquids and solids. This is particularly critical in gas turbine applications where severe damage may be caused to the turbine if the gas is not ultra clean and dry. Metered fuel gas is normally required at a steady operating pressure and at a safe temperature. The clean fuel gas is maintained above both dew point and hydrate formation temperatures.
Advantages:
Increases reliability of gas engines and turbines
Decreases maintenance costs and reduces unscheduled downtime
Increases recovery of liquids
Contains no moving parts, simple to operate and maintain
NOJOOMALDUHA LCC Co. designs and supplies heat transfer equipment like fire heater to the process plant and refinery in vary size and type.
NOJOOMALDUHA LCC Co. uses the latest Computer Aided Design & Engineering (CAD/CAE) and apply techniques to designs furnace. Good experience in boiler design and good basic knowledge in heat transfer help us to design fire heaters in high performance.
Careful planning and international sourcing of materials and fabrication ensures every project is planned to meet the highest quality and safety requirements on schedule in NOJOOMALDUHA LCC Company.
NOJOOMALDUHA LCC Co. is an UAE EPC contractor for desing and fabrication of the Multi media fine Filter. The multi-media filters shall remove suspended organic matter and inorganic particles from the water with removal efficiency of up to particles larger than 2 µm .
Advantage :
High Removal Efficiency of %98 at 2 µm
Providing higher water flow rate
Low backwash requirement
Low cost of maintenance
Backwash Of Multi-Media Filters
In order to reduce pressure drop,the filters are periodically taken out of service and cleaned by backwashing to remove the filtered material. Backwashing is usually accomplished by first injecting air to break up the bed and then expanding or fluidizing the bed with flushing water.
